Work is progressing smoothly on the spar. Here's a
shot of the forward face, after its had micro applied, a single layer of
BID, and been peel plied around the edges and joints. I did not micro
these pieces together in this shape before I did the layup, so, I added some
wood pieces (covered with tape) and weight to prevent any mis-alignment of
them during the cure of the glass. The ends have been propped up to
match the angle the pieces will have once installed on top of the rest of
the spar.
A shot of the other end. Nothing special to this
layup, no rocket science. Let it cure then micro it onto the rest of
the spar.
I scissor trimmed this layup the following morning.
That's as far as I have gotten on the site.
Having said that, know that I have built through step 6, the spar cap
layups.
Enjoy the pictures for now - I'll get the text up soon.
