 |
CS-109 and CS-118 were made per plans out of 1/4" birch
plywood. But, what mounts on them is different, of course.
As is typical for a part like this, I make up a diagram using AutoCAD
then print & spray glue to the plywood. Given I'm not making up
phenolic block bearings, the diagram instead shows the Cozy Girrls
'Control System
Bearing Assembly' with their centers matched to the center of where the
phenolic bearing would go.
Some folks have moved to the FMN-10 bearing (one step upgrade from the
phenolic) but..... c'mon.... have you seen one of those?
Want that as the pivot point for your aileron control? I don't think
so. They didn't pass the 'do I want to put this in my airplane' test,
to say the least. |
